imported_goaT

would this welder be ok for doing body work and exhaust work? i think the 70Amps is to low or is it ok? and one bad thing i suppose is the heat setting -theres only 4. but for the time being until i invest in a good welder would this work?
thanks:

Mig Wire Feed Welder : 70 A wire-feed welder
Infinite wire speed control
High-efficiency transformer; heat selection dial with four settings
Includes wire-feed welder, gas regulator, gas hose, two hose clamps, welding shield, one spool of flux-core wire, hammer/brush, quick-start guide and instruction manual
Uses MIG (gas) or flux-core (gasless) wires

imported_sonomagirl

i would be a little skeptical with a 70amp, i would stick with a 120amp... but, that's just my 2cents - anyone else have an opinion??

imported_Draggintoy

the Mig pak 15 works pretty good for stuff like that.