i found these pictures online.....hope the guy doesnt mind but here it is








question is....Is that a stock hood, bumper, and fenders? (friend says its not but i think it is) .......Can you simply cut the hood, fender and bumper to get those 1 pices to fit?

 

Look at this pic



C-speedracing's Project Integra - has the full JDM ITR front end conversion... meaning all new bumper, fenders, and hood from a JDM ITR.

The one in your pic only has the JDM ITR headlights, all the front end panels are nothing like the JDM ITR panels. SO yes you are right, those panels on the Civic are all stock, which have been molded to fit the lights. And it's a pretty clean job too, most front and rear end conversions come out looking like ***.

 

but then again...maybe that's why there are no close-up pics...

 

yea ive seen the whole jdm front end conversion alot on the tegs....but not that much on a 5th gen civic....i remember an article on superstreet with a maroon turbo 92-95si with the whole conversion including the back as well

 

there is suppost to be a one piece headlight for 92-95 Civics but I have never found it. I think I will do that conversion it looks nice and doesn't seem to need too much mod.

 

How ar eyou going to do it if you have never seen it?

 

I've seen it before. It's basically the same as the USDM headlight and corners just one piece instead of 2. If you can get your hands on a set it a plug 'n play I beleive. No modding of anything, maybe just extra wires for the city lights.

 

why bother searching for piece lights hehehhe..I'd rather get some nice Vision corners instead

damn I wish I had an EG hb

 

I would do it in a flash if the headlights came with all the HID goodies...

 

oops....

I ment I will do the mod above... not the one piece stock.