Can someone help me with this, I have obviously been smoking too much crack again.

I can't get these %$^&# lights focused in the right places.

I know where all the adjustment bolts are, just can't get it to work right..

Anyone have any experience with this...

Would apprieciate the help..

 

Hey man, your best bet is to do the large scale adjustments by moving the actualy headlight housing. When they were installed they were probably just eye-balled and were not istalled with the beam in mind (assuming you did not do the install)

What I did was adjust the headlights so that they appeared to be center within the housing, then I moved the actual headlight to as close to the right position without it looking like the headlights were scew or messed up. I then used the directional screws on the back of the housing the adjust the beam to the best I could do.

So in a nutshell, move the headlight, then move the beam. (because you will probably notice that the directional screws on the back have a limited range of motion)

I hope this helps.