i want to know how to do this or if anyone can do it for me and i'll pay them. I need to cut my fenders for a sidemarker install. The holes would be a rectanglular shape on both the driver and passenager side. I just don't want to mess up my fenders. If not i'll take it to the shop.
Help please.

 

just carefully drive a hole to get a saw blade in there then go nuts...

 

Tape the area to be cut...

Use a dremel or nibbler..

Start small and work out..

Make sure they are in the right spot..

I will also say that the "templates" on the internet are incorrect on placement..

Without removing the fenders wiring will be a bit tricky..

 

use a dremel tool with a sharp cutting tip after drilling a hole

 

ya i installed mine on the car and the wiring was a bit tedious....

 

be careful not to drill too hard which may result on a dent or (surface irregularity, lol). My advice, use the sharpest bit possible designed to drill though metal

 

get a professional to do it! u can blame them if they mess up! i bet it would cost next to nothing to do!