Hello

I need to change the dizzy cap / rotor.
I pulled off the cap and the ROTOR does not have the "screw" to tighten/remove it. Every Honda dizzy i've worked on has one.
Some have said to "pry" it off... but i don't want to cause any damage to the dizzy... also what do i do if this rotor does not fit? It's a Honda 99 Si-R
P# 30103-P08-003

 

they have a screw.. Did you crank the motor over to reveal the screw?

If there is no screw in the hole, just pull her out.

 

There is no screw...this is the 1st honda dizzy i worked on without a screw on the rotor.
Some ppl have told me that some gen b series vtec dizzys do not have a screw.
I do not wanna pry it off and risk breaking it.
Clearly even if i get it off..the dizzy was not desighned for a rotor with a screw

 

never heard of one with out a screw holding it on??

 

If theres no screw it's just a clip on then. Many distributors use this method.

Just pull it firmly towards you. If it doesn't come off with you using all your might, then there is a screw, you just cant find it.