whitehatch

6 Point Bolt-In Roll Cage from 2nd Generation DA Integra. Was built in the U.S. to run the car in SCCA events.
Use for competition or as a half cage.
The mountings for the driver's side impact bars were cut off, need to be grinded smooth to look right. Could use some cleaning up if using for a show car.
Also have 4 foot plates to mount on the underside of the car for the roll cage mountings.
Will this cage fit other cars? Most likely, here are all the measurements for you to find out.

$400 OBO
Will trade for 1990-1993 Integra DA front track bar, or B series skunk2 stage 2 cams

e-mail me at impulsive_rs@hotmail.com
Cage is in North Brampton

Pipe diameter: 1.5" or 38mm
Pipe thickness: .13" or 3.3mm
Main Hoop to Front Leg piping length 40"
Main Hoop to Front Leg overall length (from foot plate to foot plate) 44"
Main Hoop width: 52"
Top of main hoop to front top of cage: 27"
Height of main hoop: 43.75"