i haven't even listed them all yet !!!!!! my gosh everywhere i turn !!!!! its something new !!!!!!

 

reminds me of my H swap.. O the memories.. lol

 

k i think i have almost had enough for today !!!! i have been doing so much but i stand back and i look at the situation i still got a tranny on the floor an auto pedal assembly in there all the bolts out no steering cloum, front suspension dismantled i think what exactly have i been doing since 9 this morning !!!!!!!! every bolt is nearly impossible to remove due to location, or its rusted or geeeze i eneded up causing myself more problems when i dropped the auto tranny and forgot to remove the o2 sensor wire mount and it ripped it right out of the o2 sensor then when i put the tranny on i realized the wire and some little silver thing were inside my clutch area!!! so i took the tranny off again !!!!!!!!! now back ot square one !!!! will the car run without an o2 sensor for a little bit like an hour so i can go get another one ? after i get more back together lol

 

I doubt it would run without an o2 sensor but hey I say try it mosty likely you get a code and run rich

 

anyone want to come over and help with this damn task!!!!

 

 

is that JDM or USDM pedal cluster?

 

if aaron posted it. it must be jdm but either way it will all work.

 

you bastards mine was one piece !!!!!!!!!!!! i got it in now hooked up brake , gas and clutch i got the tranny bolted in and clutch adjusted just putting on engine mounts now

 

 

JDM wont work...

the brake pedal curves the wrong way and interferes with the steering column, had that prob on my car, had to get a USDM pedla cluster to work..

 

Correct..

Pic for reference purposes..

Matt you don't work with a guy named steve do you??

 

good luck with this sawp....sounds like a lot of work.....

 

yeah it'll run w/o a O2 sensor

 

it should run with out it...... my buddy's accord worked fine with out it...just make sure you don't get pulled over

 

i've been thinking about slapping in my old Si tranny.... at least then i could sell a mint DX tranny rather then an iffy Si tranny..... or i could take them both apart and swap the Si final drive into the DX then have nice gearing and a mint tranny in my car....

ah well hope your tranny swap is going good

 

steve?

hmm name doens't ring a bell... why do you ask? you can PM me

 

well now i got the starter bolt, a new o2 sensor i repaired the o2 sensor wire got everything bolted in gonna try to start it maybe i need to figure out the neutral lock better !!!! then maybe starts!!!!