I was at starbuck and when i left........ i was in a parking lot and i started going then had to stop cuz car.. then i push clutch in... leave in first... with the clutch still in it stalls... then i feel like theres no cluch .. now the clutch doesn't release all the way back.. and when i puch it fully it doesn't disengage... .

i have a new exedy organic racing clutch and a new throwout bearing and a new spring for it too..

but i'm assuming its the spring... what do you guys think?

BTW.. the cable didn't snap....

I also tried moving it by hand but it wont go up.. theres still pressure against the PP but it doesn't go down all the way... when i release the pedal... its still up a bit... and i can push it down by hand and hear the fork hit the end of the tranny... and its still still from there to move it back up....

this is horrible

 

dan has the worst luck...like I said, ur gonna have to pull the tranny off and visually inspect the spring and what not.

 

ye my luck blows....

heh.. it may have somehting to do with the actual pedal assembly rather than the tranny.... it seems its broken and doesn't go all the way down.. I'm somewhat relieved .. i'm on my way to fix it... but i have a bit of doubt in me that is the problem... but i'll let you guys know

 

i'm looking at it.. i dont think its that.. i am not to sure... but like i said the arm moves up but not all the way back down.. so tranny issue... b.c the pedal has so muh slack cuz the wire has slack in it..

 

why not take the slack out of the cable and see if that allows you to disengage the clutch?

 

there is only slack when the clutch arms is stuck.. and is not all the way down... when i push it down manually.. ( it has too much tension and wont go up by hand) the slack is gone

 

ye.. i fixed it thanks n e w ayz guys

 

I lied seems like it was a temproary fix.. i believe now the fork is broken or the bolt holding it.. i'llt ake the tranny out tommorrow