ok guys, i have seen this covered on another board and some on this one

what im looking for is what is needed to fully swap the K20A3 into an eg...

after engine, tranny and ecu, what else is needed and what would be a cost for the parts...

i know hasport makes mounts for the eg but what else is nessecary

thanks for the help

as much detail as possible would help the best, thanks

 

axles, wiring, shifter are all things to consider. k20a.org

now, I could do a big ole writeup on this bitsh, but why bother when someone has already done it for me

http://www.k20a.org/EGK1.pdf

my buddy and I are doing his del Sol K20A (JDM) over winter...

 

Looks like you didn't search, eh? :P tsk tsk tsk

 

i did but there wasnt one on this site and other sites i found didnt give me a good description of parts and such


thanks Bruno

im looking into this over winter aswell... still on the fence

 

when its all said and done, you'll have to spend roughly $5-6000 on just the parts needed for the swap. motor & tranny not included. to be honest, its a waste of money especially when you'll be $10K deep and have only an ecu and header on it.......but, those 05' k's make sick power with just an ecu and intake....200+whp & 149wtq...its your call.

 

The complete swap kit is about $3000USD for everything, incl axles and whatever else, complete SWAP KIT, just add engine, ECU, tranny, and wiring.

 

Just talk to COW, at 2.3% interest rate, it is like fianace another car! Why not eh?