i would like to know how much (un-assisted) hp i could get out of a D17A motor?

price limit it about $5500.00

please reply with parts list (detailed) and a location where i can get all of these parts installed...

thanx

Adrian

 

for that much your better off swapping a k20 in your car

 

sorry, check 7thgencivic.com for more info, a lot of ppl do pointlless mods to the d17, there isnt really much you can do to get some decent power out of it other than turbo, but with that budget a k20 (rsx type s) swap is your best bet.

someone is selling a fully legit full swap for 3500, and the labour and all other small parts necessary and even exhaust can all be covered with your 500 budget

good luck

 

Sorry, there's no way to get a K20A2 swap in there for $5500

Engine & Tranny - $3500
Mounts - $800
Harness - $550
ECU - $1000+
Custom Shafts to fit the 32mm Civic outer hubs
EP3 Radiator
Misc. items for power steering, clutch line, etc.

all of that plus labour which will run in the $1200-1500 range for this kind of swap.

It's a little easier than putting a K into an EG/DC because headers and exhausts bolt-up, but it's not very possible for $5500

 

shyt, the cost of mounts came down..
last year they were still running $1500


weak engine..
you could turbo it, but i'd be leery of anything over 8lbs without doing the internals, and there isn't a shyt load available off the shelf for guts so.....

 

thanx guy's

at least you guys are honest

i'll just keep saving up

btw is there a difference between the motor that comes in a canadian type-s and a Jap type-r?

 

yea

that jap type r makes 220hp the type s here makes 200hp

not too long ago someone was selling a complete swap with everyhting u can possibly need (subframe, mount, etc..) for liek 2800 cdn

it was a ep3/base rsx swap

 

all i know d17's suck ***! swap a k20a you'll be happy!

 

d17 are teh sux.